NAD C 388 オーナーマニュアル

•  This indicator will be amber when the C 388 is in standby mode.
•  When the C 388 is powered up from standby mode, this indicator 

will change from amber to blue color.

•  Press Standby button to switch ON the C 388 from standby mode. 

The Power indicator will change from amber to blue color. 

•  Pressing Standby button again switches back C 388 to standby 

mode. The Power indicator will change from blue to amber color. 

•  The Standby button cannot activate the C 388 if the rear panel 

POWER switch is off.

IMPORTANT NOTES
For the Standby button to activate, the following must occur:

•  The navigation [d/f/a/s] and [ENTER] buttons are used to go 

through menu options and selections.  

•  Use [d/f/a/s] to go up, down, left or right given options or 

selections. 

•  The middle round button is designated as [ENTER] button. This is 

normally pressed to complete a selection, procedure, sequence or 

other applicable functions.

•  A 1/4” stereo jack socket is supplied for headphone listening and 

will work with conventional headphones of any impedance. 

•  The volume, tone and balance controls are operative for 

headphone listening. Use a suitable adapter to connect 

headphones with other types of sockets, such as 3.5mm “personal 

stereo” jack plugs. 

•  Show visual and menu information according to the selected 

settings.  

•  The following Main menu options are shown in the display - Source 

Setup, Settings and BluOS Setup (available if MDC BluOS module is 

installed). 

Use the SR 9 remote control or front panel navigation [d/f/a/s] and 
[ENTER] buttons to go through menu options and selections. 

•  Point the SR 9 remote control at the remote sensor and press the 

buttons.

•  Do not expose the remote sensor of the C 388 to a strong light 

source such as direct sunlight or illumination. If you do so, you may 

not be able to operate the C 388 with the remote control.  

Distance: About 23ft (7m) from the front of the remote sensor.

Angle: About 30o in each direction of the front of the remote sensor.

7  a SOURCE s

•  Press a SOURCE or SOURCE s to select Sources. 

•  The VOLUME control adjusts the overall loudness of the signal sent 

to the loudspeakers. The Volume control is characterized by perfect 

signal tracking and channel balance. It provides a highly linear and 

low noise operation.

•  Turn clockwise to increase the volume level and counter clockwise 

to lower it.

•  The default volume level is -20dB.

VOLUME

SOURCE

© NAD  C388

Hybrid Digital DAC Amplifier C