Marantz PM-14S1 オーナーマニュアル

2

ENGLISH

Point the remote control unit at the remote sensor when 
operating it.

30°

Approx. 23 ft/7 m

30°

šThe set may function improperly or the remote control unit 

may not operate if the remote control sensor is exposed to 
direct sunlight, strong artificial light from an inverter type 
fluorescent lamp or infrared light.

šWhen using 3D video devices that transmit radio 

communication signals (such as infrared signals etc) 
between the various units (such as the monitor, 3D glasses, 
3D transmitter unit etc), the remote control unit may not 
operate due to interference from those radio communication 
signals. If this occurs, adjust the direction and distance of the 
3D communication for each unit, and check that the remote 
control unit operation is not affected by these signals.

šBefore turning the power on

Check once again that all connections are correct and that 
there are no problems with the connection cables.

šPower is supplied to some of the circuitry even when the 

unit is set to the standby mode. When going on vacation or 
leaving home for long periods of time, be sure to unplug the 
power cord from the power outlet.

šAbout condensation

If there is a major difference in temperature between the 
inside of the unit and the surroundings, condensation (dew) 
may form on the operating parts inside the unit, causing the 
unit not to operate properly.
If this happens, let the unit sit for an hour or two with the 
power turned off and wait until there is little difference in 
temperature before using the unit.

šCautions on using mobile phones

Using a mobile phone near this unit may result in noise. If 
that occurs, move the mobile phone away from this unit 
when it is in use.

šMoving the unit

Turn off the power and unplug the power cord from the 
power outlet. Next, disconnect the connection cables to 
other system units before moving the unit.

šAbout care

šWipe the cabinet and control panel clean with a soft cloth.
šFollow the instructions when using a chemical cleaner.
šBenzene, paint thinner or other organic solvents as well as 

insecticide may cause material changes and discoloration 
if brought into contact with the unit, and should therefore 
not be used.

The supplied remote control can be used to control Marantz 
Integrated Amplifier and Marantz Super Audio CD player.
šThe remote control may not operate some products.

e Put the rear cover back on.

q Remove the rear lid in the 

direction of the arrow and 
remove it.

w Load the two batteries 

properly as indicated by 
the marks in the battery 
compartment.

šInsert the specified batteries in the remote control unit.
šReplace the batteries with new ones if the set does not 

operate even when the remote control unit is operated close 
to the unit. (The supplied batteries are only for verifying 
operation. Replace them with new batteries at an early date.)

šWhen inserting the batteries, be sure to do so in the proper 

direction, following the 

q and w marks in the battery 

compartment.

šTo prevent damage or leakage of battery fluid:

šDo not use a new battery together with an old one.
šDo not use two different types of batteries.
šDo not attempt to charge dry batteries.
šDo not short-circuit, disassemble, heat or dispose of 

batteries in flames.

šDo not keep the battery in a place exposed to direct sunlight 

or in places with extremely high temperatures, such as near 
a heater.

šIf the battery fluid should leak, carefully wipe the fluid off the 

inside of the battery compartment and insert new batteries.

šRemove the batteries from the remote control unit if it will 

not be in use for long periods.

šUsed batteries should be disposed of in accordance with the 

local regulations regarding battery disposal.

šThe remote control unit may function improperly if 

rechargeable batteries are used.