Zvox SoundBar SB500 オーナーマニュアル

Your Current TV Remote Can Control Your SB400/SB500.

After following the steps outlined in this guide, your cable or satellite
remote will adjust the volume output from your soundbar system. Please
Note: If you have a DirecTV remote control, use the DirecTV remote
guide included along with this instruction sheet.

The steps involve pressing the Volume, Mute, and Power buttons of your
preferred remote control with the remote positioned close to the numeric
display of the soundbar. Once complete, the soundbar will respond to
the buttons it has learned from your preferred remote control.

To insure accuracy, the learning routine records each button’s
commands twice, then confirms a successful button learning.

ZVOX

Audio has specific instruction sets available for a variety of

popular remote controls. These instructions provide an alternate method
for configuring your SB400/SB500 to respond to your preferred remote
control. If you cannot easily teach the SB400/SB500 to respond to your
preferred remote control, please contact ZVOX Audio about additional
instructions for your preferred remote control.

Stand or sit within easy reach
of the soundbar’s control buttons
(the end on your right hand side).

You will need to press two buttons on
the SB400/SB500 end panel to start the
learning process. Then you will press four
buttons on your preferred remote control.

Locate the following
buttons on your
remote control:

VOLUME UP

VOLUME DOWN

MUTE

POWER

The learning process
involves pressing these
four buttons in sequence.

This remote is only an example. Your
remote is probably different. Please
locate these buttons on your remote.

Press both
VOLUME buttons
on the soundbar
until “Lrn” appears
(about 4 seconds).
Then release both
VOLUME buttons.

࠮ Get ready

to press
VOLUME UP
on the Remote
Control.

When

appears, press

VOLUME UP for 1 second.

You should see

When

appears, press

VOLUME UP for 1 second, again.

You should see

followed by

When

appears, press

VOLUME DOWN for 1 second.

When

appears, press

VOLUME DOWN for 1 second, again.

You should see

followed by

When

appears, press

MUTE for 1 second.

You should see

When

appears, press

MUTE for 1 second, again.

You should see

followed by

When

appears,press

POWER for 1 second.

You should see

When

appears, press

POWER for 1 second, again.

You should see

followed by

PREPARE

LEARN BUTTONS

YOU ARE DONE!

If you see the “no change” message (nocH) during the learning routine,
the SB400/SB500 system system did not accept the infrared code.
The current step in the learning routine will repeat.

Error Message of
the SB400/SB500
Learning Routine

You should see

volume up

volume down

mute

power