Samsung HT-J5500W オーナーマニュアル

 - English

Settings

 

✎

To delete all Preset FM stations at once, press 
the 

 button for about 5 seconds 

in FM Manual mode until dEFAULT pRESET 

appears on the display.

You can record your favorite radio broadcast on a 
USB storage device.
1.  Insert a USB device into the USB jack on the 

front of the product.

2.  Press the 

 button to select FM, and 

then press the 

, 

 button to 

select the station you want to record.

3.  Press the 

 button to start recording. The 

recording process begins.

 

The recorded time is displayed on the left and 
the recording time still available, based on 
the amount of free space in the USB storage 
device, is displayed on the right.

4.  Press the 

 button to finish your recording. 

The recording is stopped and saved as an .mp3 
file at the same time. To play the recorded file, 
refer to "Playing Files on a USB Device".

 

✎

The recorded file is saved in the Tuner folder 
which is created automatically.

 

✎

Only the 

5V 0.5A

 (OPEN/CLOSE), 

5V 0.5A

 (POWER), 

, 

, and 

/

, buttons are operable 

while FM radio is being recorded.

 

✎

If you don't press any buttons while recording, 
the screen saver will be enabled.

 

✎

Sound effects, such as DSP, EQ, etc., are not 
recorded during FM radio recording.

 

✎

The radio is recorded at a set, default volume 
even if you change the volume or press the 

 button during the recording process.

 

✎

If you remove the USB device or Power Cable 
during the recording process, the portion of 
the file which has already been recorded may 
not play back.

 

✎

Recording will not start if the remaining free 
space in the USB storage device is less than 
2MB.

 

✎

If the USB device is removed or has insufficient 
space (under 2MB), the appropriate message 
is displayed and the recording stops.

When you connect this product to a network, you 
can use network based applications and functions 
such as BD-LIVE and upgrade the product's software 
through the network connection.

To begin configuring your network connection, 
follow these steps:
1.  In the Home screen, select Settings, and then 

press the v button.

2.  Select Network, and then press the v button.
3.  Select Network Settings, and then press the v 

button.

4.  Go to the instructions for Wired networks 

starting below or the instructions for Wireless 
networks on the bottom left of next page.

 

Ğ

After following Steps 1 to 3 above:
1.  In the Network Settings screen, change 

Network Type to Wired. Then, select Connect 

and press the v button. The product detects 

the wired connection, verifies the network 
connection, and then connects to the network.

2.  When it is done, highlight Ok, and then press 

v button.

 

Ğ

If you have a static IP address or the automatic 
procedure does not work, you'll need to set the 
Network Settings values manually.
After following Steps 1 to 3 above:
1.  In the Network Settings screen, change 

Network Type to Wired. Then, select Connect 

and press the v button. 

The product searches for a network, and then 
displays the connection failed message.

 

✎

If it is possible to connect the home theater 
to your network wirelessly, select Change 
Network at this point, change the Network 
Type to Wireless, and then go to the 

instructions for wireless networks on the 
bottom left of next page.