Nikon Coolpix SQ ユーザーガイド
VAA12201-R.3581.A
- A9 ・ SQ -
⑤
Eyelet
・
Attach the eyelet to the battery case with 2 screws (#822).
⑥
CR PCB (Cradle connection PCB)
・
Solder the red, white and black wires to the battery contacts.
・
Solder the 10 wires of the harness to the CR PCB.
・
Arrange the end of harness and the edge of the battery frame so that the length between them becomes 60
~
63 mm. Fix them and 3 wires of the battery contacts with the tape (#176 ① ).
・
Fix the harness on the CR PCB side with the tape (#176 ② ).
Battery case
#822×2
Eyelet
60mm
・
Put the harness and 3 wires of battery contacts together, and wind the tape (#176 ③ ) around them at the
position of approx. 3mm from the edge of the battery frame (ref. Fig.3)..
3mm
#176×2
①
②
TA-0005
#176 ③
Black:Power source base plate
Black: 〃〃
Red:Power source base plate
Red: 〃〃
Note)
through hall
Gray:
Power source PCB
White: 〃〃
Orange: 〃〃
Orange: 〃〃
Blue: 〃〃
Blue: 〃〃
Red
White
Black
Note )
Be careful not to
contact a through hall in
soldering work.
CR PCB