Rollei dr4 ユーザーガイド
47
Symptom 2 Even if you check [The same image will not be saved] in the DL-10
Optional Settings, the same images are loaded into your computer.
Measure
The camera's clock is incorrectly set or the camera's clock information has been reset.
To allow the [The same image will not be saved] function to work properly, the camera's clock
information must be set properly. Set it properly.
To allow the [The same image will not be saved] function to work properly, the camera's clock
information must be set properly. Set it properly.
Symptom 3 Files loaded from the camera into the computer were deleted. You
attempted to load the same files from the camera again but failed.
Measure
If [The same image will not be saved] is checked in the DL-10 Optional Settings, files loaded into
your computer once cannot be loaded again. In the DL-10 Optional Settings, uncheck [The
same image will not be saved].
your computer once cannot be loaded again. In the DL-10 Optional Settings, uncheck [The
same image will not be saved].
Symptom 4 Cannot play back movies
Measure
DirectX may not be installed. (Windows 98/98SE/Me/2000) Install DirectX from the CD-ROM.
Symptom 5 DL-10 is always activated when the camera is connected to a Windows XP
computer through a USB cable.
Measure
Connect the camera to the computer through the USB cable, and then open My Computer from
the Start menu on Windows Taskbar. Right-click the camera icon on the My Computer screen
and click Properties to open the camera's Properties screen. Click the [Event] tab on the
Properties screen. For the computer operation, select "None" or "Select Program to Execute "
and click OK. If "None" is selected, nothing happens when the camera is connected to the
computer. If "Select Program to Execute" is selected, a screen is displayed each time the
camera is connected to the computer. Then you can choose a program to activate.
the Start menu on Windows Taskbar. Right-click the camera icon on the My Computer screen
and click Properties to open the camera's Properties screen. Click the [Event] tab on the
Properties screen. For the computer operation, select "None" or "Select Program to Execute "
and click OK. If "None" is selected, nothing happens when the camera is connected to the
computer. If "Select Program to Execute" is selected, a screen is displayed each time the
camera is connected to the computer. Then you can choose a program to activate.