Sony AF DT 50 mm f/ 1.8 SAM Lens マニュアル

SAL50M28 (MACRO 2.8/50) (50mm F2.8 Macro)

Adhesive bond (B-40): J-6082-614-A

1.

Attach the first cam ring linkage plate block to the first cam ring, and apply the adhesive bond (B-40) to the two screws and tighten

them as shown in the figure.

Note: Attach the pin of the first cam ring linkage plate block to the wide chamfered edge side of the first cam ring.

2.

Install the first cam ring so that the post of the first cam ring linkage plate block fits into groove A of the inner barrel. Then install it

with the first cam ring adjust washer.

Adhesive bond (B-40): J-6082-614-A

Attach the front lens barrel, and apply the adhesive bond (B-40) to the three screws and tighten them as shown in the figure.

 Apply the
adhesive bond (B-40)

Chamfered edge (Wide)

Chamfered edge
(Narrow)

First Cam Ring

First Cam Ring
Adjust Washer

1st Cam Ring Hold Ring

First Cam Ring

Aperture Inner Barrel

Inner Barrel

Pin

Groove A

Groove A

First Cam Ring Linkage
Plate Block

Apply the
adhesive
bond (B-40)

Front Lens Barrel