Comp X Security Products Inc 421860 ユーザーズマニュアル
If the engine is not run frequently and allowed to thoroughly
warm up, this water will accumulate, mix with the engine oil
and form a sludge that is harmful to the engine.
warm up, this water will accumulate, mix with the engine oil
and form a sludge that is harmful to the engine.
OIL COOLER: FLHTCUSE3
The FLHTCUSE3 is equipped with a factory installed oil cooler.
Always keep the cooler clean and free from dirt and debris.
This will help maintain maximum cooling efficiency.
Always keep the cooler clean and free from dirt and debris.
This will help maintain maximum cooling efficiency.
TRANSMISSION LUBRICATION:
FLHTCUSE3
FLHTCUSE3
General
The transmission lubricant level should be checked monthly.
Your motorcycle comes equipped with Screamin' Eagle SYN3
Synthetic Motorcycle Lubricant. For transmission lubrication,
it is not recommended to mix SYN3 with other lubricant prod-
ucts.
Synthetic Motorcycle Lubricant. For transmission lubrication,
it is not recommended to mix SYN3 with other lubricant prod-
ucts.
Refer to Table 32. The transmission should be drained and
refilled with fresh lubricant at specified intervals.
refilled with fresh lubricant at specified intervals.
NOTE
When checking the transmission lubricant level, motorcycle
should be leaning on the jiffy stand.
should be leaning on the jiffy stand.
Check Lubricant Level
1.
Ride motorcycle until engine is warmed up to normal
operating temperature.
operating temperature.
2.
When the engine reaches normal operating temperature,
turn the engine off and lean the motorcycle on its side-
stand.
turn the engine off and lean the motorcycle on its side-
stand.
3.
See Figure 49. Unthread and remove the filler plug/dip-
stick.
stick.
4.
See Figure 50. Wipe off filler plug/dipstick and place it
back in the filler hole. Do not thread in. (Dipstick should
rest on threads of the case.)
back in the filler hole. Do not thread in. (Dipstick should
rest on threads of the case.)
5.
Remove the plug/dipstick and check the level. The lubri-
cant level should lie between the A (ADD) and F (FULL)
marks on the dipstick.
cant level should lie between the A (ADD) and F (FULL)
marks on the dipstick.
Be sure that no lubricants or fluids get on tires, wheels or
brakes when changing fluid. Traction can be adversely
affected, which could result in loss of control of the
motorcycle and death or serious injury. (00047d)
brakes when changing fluid. Traction can be adversely
affected, which could result in loss of control of the
motorcycle and death or serious injury. (00047d)
144 Maintenance and Lubrication