Comp X Security Products Inc TP-100 ユーザーズマニュアル

StealthLock, Keyless Invisible Security

Notes – Battery Installation, User Codes, and Modes

Battery Installation –

Write down the date that batteries were first installed.  Make a note on your calendar to
replace all batteries on an annual basis.

__________          __________          __________          __________

User Code –

Write down your user code below to insure it is not forgotten.  Keep in safe place.

__________          __________          __________          __________

Supervisor Code –

Write down your supervisor code below to insure it is not forgotten.  Keep in safe place.

__________          __________          __________          __________

Receiver Latch has been programmed to this Mode –

□  Single Use Mode or …

□ Non Single Use Mode

□ Self Lock Mode or …

□ Passage Mode

□ Learn Enable or …

□ Learn Disable

Receiver Latch has been dedicated to a Transmitter Pad with this TPID –

__________ __________ __________ __________

StealthLock, Keyless Invisible Security

Regulatory Information

The user is cautioned that changes or modifications not expressly approved by CompX
Timberline could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.  However, there is no guarantee that interference will not occur in a
particular installation.   If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.