Exegin Technologies Limited Q53 ユーザーズマニュアル
64
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2009
viii. Reference Information
Complete Command Reference
Complete Command Reference
Miscellaneous commands
These commands do not fall under any specific section of the command line interface
shell but they are used quite frequently.
shell but they are used quite frequently.
store net mask netmask
Store the subnet mask for the Q53.
For example:
store tcpip 1 mask
255.255.255.0
store net opts[[-]dhcp]
Enable or disable the automatic DHCP
requests for IP addresses upon bootup.
Prefix the ‘DHCP’ option with a dash (‘-’) to
disable the option; otherwise it is enabled.
requests for IP addresses upon bootup.
Prefix the ‘DHCP’ option with a dash (‘-’) to
disable the option; otherwise it is enabled.
For example:
store tcpip 1 opts -dhcp
store net rxbuf packets
Determine the receive window size for the
Q53. Usually the packets value ranges from
2-8 with the lower number allowing for
more simultaneous TCP connections with
the Zigbee gateway bridge device.
Q53. Usually the packets value ranges from
2-8 with the lower number allowing for
more simultaneous TCP connections with
the Zigbee gateway bridge device.
For example:
store net rxbuf 2
store zbnwk opts [-]edscan
Enable/disable power-up energy scan on the
Zigbee radios.
Zigbee radios.
store zbmac freqband [[-]868]
[[-]915] [[-]2400]
Sets the freqency band for each Zigbee
radio.
radio.
store zipt port portnumber
Sets the UDP port number to be used for
bridging Zigbee traffic over the IP network.
The default port number is 17755.
bridging Zigbee traffic over the IP network.
The default port number is 17755.
Table 7—Miscellaneous Commands
Command Syntax
Description
close <sd>|all
Close the network connection defined by the
socket descriptor. Socket descriptors can be
obtained using the
socket descriptor. Socket descriptors can be
obtained using the
netstat
command.
If the argument
all
is entered, then all
active network connections will be
terminated, including the telnet session in
which the command was entered.
terminated, including the telnet session in
which the command was entered.
Table 6—Store Command Options
Command Syntax
Description