ONKYO CBX-500 W 10345 ユーザーズマニュアル

En-

46

To display the day and time, press the remote controller’s 
[DISPLAY] button for 2 seconds. The day and time will 
be displayed continuously.

To cancel the time display, press the [DISPLAY] button 
again.

If the CBX-500/CBX-600UKD is on Standby, pressing 
the [DISPLAY] button will display the day and time for 
8 seconds.

If for some reason the AccuClock function doesn’t set 
the clock correctly, you can specify which FM station the 
AccuClock function uses. This is especially useful if you 
live close to a country’s border where stations from dif-
ferent time zones can be received. Note that the FM sta-
tion must support RDS CT (Clock Time) information.

Use the Up/Down []/[] buttons to select 
“AccuClock”.

The frequency of a station that the unit has previ-
ously searched for may appear on the display.

Use the TUNING []/[] buttons to specify 
the frequency of a station that’s broadcast-
ing RDS CT information.

Press [ENTER].
The specified frequency will be used the next time 
the AccuClock function runs.
If the specified station is not broadcasting RDS, 
“Not RDS” will be displayed and it will not be pos-
sible to set the clock.

The unit enters Standby mode, and “AccuClock…” 
appears dimly on the display while the AccuClock 
function attempts to set the clock.

If the clock is set successfully, the day and time 
will be displayed brightly for 2 seconds, as shown.

Notes:
• Once the AccuClock function is working, it will auto-

matically update the clock daily at 2, 3, and 14, but 
only when the unit is on Standby.

• If you’ve set the AccuClock function, but it’s not 

updating the time automatically, make sure a strong 
signal is being received from the specified RDS sta-
tion. Also make sure that the station is actually broad-
casting CT information. Try another station, if 
necessary.