Selex ES SPA F567DHDE-HP ユーザーズマニュアル
SELEX Communications
Information contained in this document may not be used, applied or reproduced for any purpose unless agreed
by SELEX Communications S.p.A. in writing
20
July 2010
5.3 Line interfaces
5.3.1 4W and 4W+E/M Link
If the RBS is equipped with a LIF module on the rear panel 4 4W+E/M connectors are present. The
following figure shows the rear panel of the LIF module. Configuration of the feature of this four links is
out of the scope of this manual. The electrical interface is described in this section. Usually these AF
links are used to establish RBS to RBS links or RBS to RNFE links.
Interconnecting points
Type of connector terminating
the cable
Type of cable/conductor
4W or 4W+E/M Link port
RJ45 male connector
AWG 24 Category 5
4x 4W or 4W(+E/M)