HIWAVE Inc HW-RFR900T ユーザーズマニュアル
-9-
z Log Window
The log window is used to display all the messages and data sent to and from the
reader board. This information is also stored in the rfid-reader.log file which can
be opened with a text editor (Notepad).
reader board. This information is also stored in the rfid-reader.log file which can
be opened with a text editor (Notepad).
The relevant information returned by the Reader (transponder response, register
content) is always in brackets to distinguish it from other data in host-to-reader
data exchange.
content) is always in brackets to distinguish it from other data in host-to-reader
data exchange.
z Frequency selection
Frequency selection field and four buttons on the right side of the GUI window
allow user to select operation frequency. The two buttons on the left change
frequency in 200 kHz.
allow user to select operation frequency. The two buttons on the left change
frequency in 200 kHz.
z Control buttons
The following buttons change operation of the Reader:
9 AGC – Automatic Gain Control setting
9 AGL – Automatic Gain Leveling setting
9 Enable RF Power – turn on / off RF power
9 AGL – Automatic Gain Leveling setting
9 Enable RF Power – turn on / off RF power
z COM port
If automatic port selection fails upon GUI initialization you can select the port
and try to execute the “Inventory Round” operation in the EPC tab. In case the
Reader will be reset (or removes power during RF debug tab measurement)
Reconnect button should be used to reestablish connection.
and try to execute the “Inventory Round” operation in the EPC tab. In case the
Reader will be reset (or removes power during RF debug tab measurement)
Reconnect button should be used to reestablish connection.
Current Frequency
Coarse adjustment buttons
Fine adjustment buttons