Skullcandy 2XL20130002 ユーザーズマニュアル

Power On – Press and hold the MFB unil the LED flashes 

blue and the ascending tone plays through the 

headphones.

Power Off – Press and hold the MFB until the LED turns 

RED and the descending tone plays through the 

headphones.

Pairing – While power is off, hold the MFB until the LED 

alternates flashing BLUE and RED.

Un-pairing – Press and hold the volume up and volume 

down buttons until you hear two short tones. 

Pause – Press the MFB once to pause and once again to 

play. 

Volume Up – Press the volume up button. A tone will sound 

at maximum volume.

Volume Down – Press the volume down button. A tone will 

sound at minimum volume.

Next Track – Press and hold the volume up button.

Previous Track – Press and hold the volume down button.

Answer Call – While paired, push the MFB once.

Hang Up Call – Push the MFB once.

Charging –The LED will be Red while charging and turn 

Blue once fully charged. 

Low Battery – The LED will flash Red and a tone will sound 

4 times.

®

Note: This equipment has been tested and found to comply 

with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses, and 

can radiate radio frequency energy, and if not installed and 

used in accordance with the instructions, may cause 

harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user 

is encouraged to try to correct the interference by one or 

more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and 

receiver.

– Connect the equipment into an outlet on a circuit 

different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician 

for help.

You are cautioned that changes or modifications not 

expressly approved by the party responsible for compliance 

could void your authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, 

including interference that may cause undesired operation.

This device complies with Industry Canada’s licence-exempt 

RSSs. Operation is subject to the following two conditions: 

(1) This device may not cause interference; and 

(2) This device must accept any interference, including 

interference that may cause undesired operation of the 

device. 

Le présent appareil est conforme aux CNR d'Industrie 

Canada applicables aux appareils radio exempts de licence. 

L'exploitation est autorisée aux deux conditions suivantes : 

(1) l'appareil ne doit pas produire de brouillage, et 

(2) l'utilisateur de l'appareil doit accepter tout brouillage 

radioélectrique subi, même si le brouillage est susceptible 

d'en compromettre le fonctionnement.