Phonetone Technology Co. Ltd. PTE2010 ユーザーズマニュアル
that has abrupt temperature and humidity changes.
1. Prepare a location. Place the equipment on a sturdy, and the surface in a
well-ventilated area, makes sure that the air vents are not blocked.
2. Connect the Inside Antenna: The patch antenna is intended for indoors or in vehicle
use only. Do not mount on a surface within 4 inches of metal. Remove the cap
from the Amplifier connector marked with CELLULAR PHONE. Screw the patch
antenna in to the CELLULAR PHONE connector and make sure to tighten it.
NOTE:
The internal antenna needs always position vertically. The inside antenna must be
mounted with a separation distance of at least 20 cm from all persons
and must not be co-located in conjunction with any other antenna or amplifier.
WARNING:
The SMA connector is fragile, handle it with extra caution, otherwise the
connector might be broken, and it might not be covered under manufacturer
warrantee.
3. Connect the Outside Antenna: The outdoor antenna is for outdoor use only. Select
an outside mounting location. For best performance, try to keep the antenna on top
of the vehicle. The outside antenna should be located in an area with at least a 12”
radius clear of obstructions, and other radiating elements. Remove the cap from the
Amplifier connector marked with OUTSIDE ANTENNA. Screw the outside antenna
in to the OUTSIDE ANTENNA connector and make sure to tighten it.
NOTE:
Keep the separation distance between the inside and outside antennas at least 5
feet apart.
WARNING:
The outside antenna must be mounted with a separation distance of at least 3 feet
from any of the vehicle occupants or nearby persons and must not be co-located
or operating in conjunction with any other antenna or amplifier.
4. Connect the Power Cord: 1) Connect the power cord to the power connect on the
top end of the amplifier marked with DC 6V, 2) connect the other end of the power
cord to a grounded alternating current (AC) outlet. Also, if the Power Cord is
connected to a power strip, make sure that the power strip is switched on. 3) The
LED light is green, indicating that the Amplifier is ready to use.
NOTE:
To prevent damage to the Amplifier, before plugging in the Amplifier to a DC/AC
power outlet, make sure that all of the connections (ANTENA to AMPLIFIER) to the
Amplifier are tight and secure.
3 / 6
WARNING: