Phonetone Technology Co. Ltd. PTEC70 ユーザーズマニュアル

4 / 6

Connect the Power Cord: 1) Connect the power cord to the power connect on

the top end of the amplifier marked with DC 6V, 2) connect the other end of the

power cord to a grounded alternating current (AC) outlet. Also, if the Power Cord is

connected to a power strip, make sure that the power strip is switched on. 3) The

LED light is green, indicating that the Amplifier is ready to use.

NOTE:

To prevent damage to the Amplifier, before plugging in the Amplifier to a DC/AC

power outlet, make sure that all of the connections (ANTENA to AMPLIFIER) to the

Amplifier are tight and secure.

WARNING:

The input voltage for the Amplifier is 6V~24V DC. DO NOT use this Amplifier with

a regular power supply that NOT range in 6V~24 V . otherwise, it will be damaged

and the user may also be injured.

(Optional)

1. Mounting the Amplifier with Velcro:

You can leave the Amplifier on top of a flat surface or use the enclosed Velcro straps to

mount the Amplifier. There are two Velcro strips (hook-and-loop pairs) in the box for

mounting the amplifier.

Determine the location where your Amplifier will be placed. Clean the intended surface

and allow it to dry. Peel the protective paper from the back of the hook sides of the

Velcro. Press the adhesive side of the Velcro strips into place on the bottom of the

Amplifier, one strip on each end. Wait 5 minutes for the adhesive to set before

attaching the loop side of the Velcro to the hook side. The adhesive bond will reach its

maximum strength after 24 hours.

With both of the Velcro loop and hook pieces attached to the back of the Amplifier, peel

the protective paper off of the back of the loop strips. Press the entire Amplifier into its

mounting place. Wait 5 minutes for the adhesive to set. Make sure the Amplifier is

firmly seated. To remove the Amplifier, rotate it across the Velcro – do not pull the

Amplifier or cables.