Zonoff Inc. EMBY001 ユーザーズマニュアル

The Z-Wave to Digital Motor Interface (ZDMI) receives Z-Wave commands from TaHomA and translates these commands for 
Somfy’s line of digital motors. In TaHomA’s Dashboard, End Users can click and drag the motorized products icon to adjust 
the product to any position between fully open and fully closed. The ZDMI is required to integrate all products powered by 
Somfy’s digital motors into TaHomA. One ZDMI per motor.

NOTE: All connections must be properly wired and the motor’s limits must already be set. Please refer to the ZDMI 
instructions for installation help. Only 1 device at a time can be included into TaHomA. 

1.  When power is first connected to the ZDMI, the Inclusion LED will illuminate briefly, then turn off. Check the ZDMI’s

connection to the motor by briefly pressing and releasing the SETUP button to make the motorized product move. Verify
that the INCLUSION LED is off. 

2.   In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  Briefly press and release the SETUP button. The INCLUSION LED will illuminate solid red. The Device Finder window will

display the message “Found a Device” and the Name and Room drop down menus will appear.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

Z-Wave

®

 to Digital Motor Interface (ZDMI)

4.  In the Device Editor window, enter a name for the motorized product, assign it to a room, and assign an appropriate 

icon by clicking on the existing Blinds icon and selecting from the list. 

5.  The ZDMI is now fully included in the network and the attached motorized product can now be controlled by TaHomA. 

Remember to activate the motorized product through TaHomA’s Device Configurator to confirm successful programming.

NOTE: Only 1 device at a time can be removed from TaHomA.

1. In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2. Briefly press and release the SETUP button. TaHomA will remove the ZDMI from the system and the icon will disappear

from TaHomA. The INCLUSION LED will turn off.

Z-Wave

®

 to Digital Motor Interface (ZDMI) 

cont’d