Zoll Medical Corp RDC001 ユーザーズマニュアル

1)  The antenna must be installed such that 20 cm is maintained between the 

antenna and users, and   

2)  The transmitter module may not be co-located with any other transmitter 

or antenna. 

 

As long as 2 conditions above are met, further transmitter test will not be 

required. However, the OEM integrator is still responsible for testing their 

end-product for any additional compliance requirements required with this 

module installed 

 

IMPORTANT NOTE: In the event that these conditions can not be met (for 

example certain laptop configurations or co-location with another transmitter), 

then the FCC authorization is no longer considered valid and the FCC ID can 

not be used on the final product. In these circumstances, the OEM integrator 

will be responsible for re-evaluating the end product (including the transmitter) 

and obtaining a separate FCC authorization. 

 

This transmitter module is authorized only for use in device where the antenna 

may be installed such that 20 cm may be maintained between the antenna and 

users. The final end product must be labeled in a visible area with the following: 

“Contains FCC ID: ZKP-RDC001. The grantee's FCC ID can be used only when 

all FCC compliance requirements are met. 

 

The OEM integrator has to be aware not to provide information to the end user 

regarding how to install or remove this RF module in the user’s manual of the 

end product which integrates this module. 

The end user manual shall include all required regulatory information/warning as 

show in this manual.