Landis+Gyr Technology Inc. ER6R1S4 ユーザーズマニュアル

Draft

Landis+Gyr

Chapter 4 - Deploying Endpoints 

User Guide

98-1723 Rev AB

29

Reconfigure retries have been exhausted

Archive Flag = Yes: The meter may transition to Archive Flag = Yes during the following 
scenarios:

A meter is permanently removed from service

Archive Endpoint command is received

Endpoint Physically Deleted: The meter may transition to Endpoint Physically Deleted 
during the following scenario:

Delete endpoint command is received (if no meter data or billable reads exist)

The Endpoints Alerts section summarizes several different endpoint related errors that could pose a 
problem with obtaining the proper billing data.

For a list of Alerts that will be triggered on the Dashboard, refer to the table in the Alarm Definitions 
section of this manual.

During normal operation, field personnel may need to replace Cellular Meters from the field. If the 
utility’s CIS software is integrated with Command Center, these types of changes will be initiated 
from the CIS software.

The following procedures should be used if CIS is not initiating the changes in Command Center.

Following is the procedure for removing a Cellular meter from service:

1.  Click Operations > Endpoints. The Endpoint/Meter Selection window will open.

2. Enter the meter number and click Go. 

3. The Endpoint/Meter Selection window will refresh and display Available Enhanced Cellular 

Tasks as shown below.

4. Select the Remove Enhanced Cellular Endpoint from Service link. The Remove Endpoint 

From Service window will appear as shown below.