Landis+Gyr Technology Inc. ER6R1S4 ユーザーズマニュアル

Draft

Chapter 5 - Managing Endpoints

Landis+Gyr

54

98-1723 Rev AB

User Guide

HAN: Get Device Info

This command returns device information for a single device by MAC 
address and Short ID.

HAN: Get Firmware

This command will return the firmware version of the HAN device associated 
with this endpoint.

HAN: Get Network Info

Returns HAN Channel ID and HAN Personal Area Network ID. This 
information is useful in determining whether a HAN network has been 
commissioned.

HAN: Initialization

This command initializes of the HAN device registers to properly display the 
TOU registers on the HAN device.

HAN: Ping Device

This command will issue a ping to the HAN device.

HAN: Register Device

This command will join a HAN device to the meter.

HAN: Send Message

Allows the user to transmit a message to be displayed on the consumers 
HAN device. 

Meter Firmware Download

Allows the user to push out new meter firmware over the air.

Modify Meter Program

Allow for selecting from a predefined list of meter programs for transmission 
to the meter. 

On Demand Read

This command will return the specified packet working in conjunction with a 
pre-defined packet definition.

Optic Lockout

This command allows the user to enable/disable/view status of optical probe 
access.

Ping

This command returns a basic response from the endpoint. This command 
is useful in determining if communication is available to the endpoint via the 
mesh network.

Read Demand Reset Data

This command will return from the meter the data captured upon the last 
demand reset.

Read Meter Table

This command provides the ability to read ANSI C12.19 table from meter. 
The response is a list of table, offset, length, and data. When the data is 
returned from the meter it can be displayed in two formats, one is the RAW 
format as returned by the meter and the other is the interpreted format. A 
simple check box allows the user to choose which format is displayed.

Reboot Module

Requests the module to perform a reboot.

Remote Connect

This command instructs the meter to connect power at the consumer 
location. This process automates the connect process, the consumer does 
not have to activate the service.

Remote Disconnect

This command instructs the meter to disconnect power at the consumer 
location.

Send Small DCW 

Command allows user to send a small DCW to an endpoint.

Reset Meter Data

Allows the user to zero out the meter readings.

Set Network Configuration

Allows the user to change the Command Center Listener address list 
associated with the endpoint among other modem settings.

Set Service Limiting

Allows the user to set a service limiting program to the meter.