RACAM - TECH LTD 1014411 ユーザーズマニュアル
Operating the System
28
When operating with an XU:
For System layout see "System Layout" on page 8.
Place XU on tripod normally 60 cm above ground, with its front/rear sides in vertical
position, laying on the longer side, with the antenna in upright position.
Press lengthily the Pwr key on the XU. For two seconds you will get one of the
following: green LED will light indicating that battery is OK or if battery is weak
green and red LED's will light, or red LED will light will indicate that you must
replace battery. After replacing battery if necessary, press Pwr key again and repeat
procedure.
Green and red LED's will blink for 3 seconds. This indicates that the XU is in
STANBY state.
During XU operation:
The greed LED will blink every 4 seconds. (If there is no communication the red
LED will blink instead the green LED). During XU transmission the red LED will
blink.
XU self-test:
Press XU Pwr key shortly. The XU will conduct a self test and if XU is in proper
condition the two LED's will light for a shoet time.
For turning XU off, press and hold the Pwr key and wait until the two LED's go on
permanently, then release the Pwr key
Preparations
Place XU on tripod normally 60 cm above ground, with its front/rear sides in vertical
position, laying on the longer side, with the antenna in upright position.
Press lengthily the Pwr key on the XU. For two seconds you will get one of the
following: green LED will light indicating that battery is OK or if battery is weak
green and red LED's will light, or red LED will light will indicate that you must
replace battery. After replacing battery if necessary, press Pwr key again and repeat
procedure.
Green and red LED's will blink for 3 seconds. This indicates that the XU is in
STANBY state.
During XU operation:
The greed LED will blink every 4 seconds. (If there is no communication the red
LED will blink instead the green LED). During XU transmission the red LED will
blink.
XU self-test:
Press XU Pwr key shortly. The XU will conduct a self test and if XU is in proper
condition the two LED's will light for a shoet time.
For turning XU off, press and hold the Pwr key and wait until the two LED's go on
permanently, then release the Pwr key
Preparations
1.
Connect squib/electric match-head to the RCU.
2.
Press the Test key on the RCU.
3.
If green LED lights, the circuit is OK. If the Red LED lights, circuit is
not functional – change the squib.
4.
Connect the squib to the consumer/shell.
Set RCUs Sleep State and Alarm
This step is optional.
Sleep
If there is time left until the event, you can put the RCUs into sleep state to extend
batteries life.
Sleep
If there is time left until the event, you can put the RCUs into sleep state to extend
batteries life.
1.
At the TU main settings menu, select SET UNITS menu.
2.
In the SET UNITS menu, select SLEEP.