Insulet Corporation 017 ユーザーズマニュアル
88
7
5. While holding the lancing device on your test site, look
through the clear cap. The blood sample should be about the
size of a pinhead.
size of a pinhead.
6. Lift the lancing device straight up; be careful not to smear the
blood sample on your test site.
Fill the blood glucose test strip with blood
1. Make sure that the strip is in the PDM and the PDM is pow-
ered on. If the PDM has powered off, take out the strip and
reinsert it (Figure 7-25), or simply press and hold the Power
button to turn on the PDM. Refer to page 54 to check Pod sta-
tus and to Confirm ID.
reinsert it (Figure 7-25), or simply press and hold the Power
button to turn on the PDM. Refer to page 54 to check Pod sta-
tus and to Confirm ID.
2. Bring the strip to the blood sample at a slight angle (Figure 7-
26).
If you do not apply the sample within 10 seconds, the strip
port light turns off. To turn it on again, press Light.
port light turns off. To turn it on again, press Light.
Avoid lancing areas with obvious veins or moles
to avoid excess bleeding. Also avoid lancing
areas where tendons or bones stick out (for
example, hand bones).
to avoid excess bleeding. Also avoid lancing
areas where tendons or bones stick out (for
example, hand bones).
Figure 7-24
Figure 7-25
Figure 7-26