Zhongshan Fu Hai Electronics Limited. XWDA0300101 ユーザーズマニュアル

1

1.  Tank out blister from the controller and obtain the antenna.
2.  Secure the antenna with its end thread into the antenna hole on the

controller.

3.  Remove the battery covers on the controller. Insert 3”AAA” batteries (not

included) into the controller, and insert 3 “ AAA” batteries (not include) into
the charger. Then replace the battery cover.

Place the tank onto the charging holder on the charger tightly. The
Recharging Lamp will turn on when charging the tank. The lamp will turn off
when the tank is fully charged.

a). If the power of the batteries inside the controller are low or out, the lamp
light will become dim of off. And it cannot charge up the tank. Replacement of
new batteries is required.
b). Ensure the orientation of tank onto the charging holder should match the
same direction engraved on them.

1.  Fully extend the antenna of the controller.
2.  LEFT BUTTON powers left side Prop (propeller). When pushed

up(forward) it turns vehicle to RIGHT.
LEFT BUTTON:
Left Motor Forward / Release for Left Motor Neutral / Left Motor Reverse

3.  RIGHT BUTTON powers right side prop. When pushed up (forward) it

turns vehicle to LEFT.
RIGHT BUTTON
Right Motor Forward / Release for Right Motor Neutral / Right Motor
Reverse

4.  BOTH BUTTON when pushed up together make the vehicle go straight

ahead.

a). When operating the controller, hold ht controller so antenna points straight
up in the air, and do not touch the antenna during operation.
b). If the speed of the tank become slowly, that means the charge-in power is
almost used up. Recharge the tank according to the aforesaid procedure.