Vanu Inc. 0PW1C0010 ユーザーズマニュアル
Vanu Anywave BSS Operator Guide — DRAFT
2.4
Power Chassis and Power Amplifiers
The Powerwave Chassis holds the Multi-Carrier Power Amplifiers (MCPAs) that are connected to each
RF Front End in the network. The outputs from the RF Front End are sent to the MCPAs via RF
cables, where the signals are amplified by +63 dB for broadcast over the antenna.
RF Front End in the network. The outputs from the RF Front End are sent to the MCPAs via RF
cables, where the signals are amplified by +63 dB for broadcast over the antenna.
Figure 2.4: Power Chassis and two MCPAs
Please Note: For proper system operation, after the BSS has started, please be sure that the “Status”
LED appears green, and that the “Status Indicator” light next to the Serial Port is not lit. Make sure the
MCPA is properly seated and secured in the chassis. If problems persist, contact Vanu Technical
Support.
LED appears green, and that the “Status Indicator” light next to the Serial Port is not lit. Make sure the
MCPA is properly seated and secured in the chassis. If problems persist, contact Vanu Technical
Support.
11