GRAUPNER CO. LTD. 16007812 ユーザーズマニュアル

23 / 28

S1002.PRO_jh_V1

One after the other, put both sticks into each of their four possible

limit positions without exerting force at the limit position and check

if the value are between -100% and +100%.
If you note that the sticks do not reach the desired values, move to

the "Stick calibration" line in the "HIDDEN MODE" menu and push

the ENT key on the right four-way keys to confirm.
The flashing arrows indicate in which direction you have to push the

sticks.
With the selection keys

of the left four-way keys allow you to

cyclically select the positions of the four calibrated sticks.
Move the stick to the end course of the indicated direction.
Confirm the calibration by pushing the ENT key.
Pushing the ESC key will terminate the process and return to the sub-

menu "Stick cali.".

Example: Bring here the respective left blinking selection arrow of

the right stick to the left limit. Tip on the SET key. So the calibration

of the right stick left limit. The circle in the middle of the stylized stick

blinks as confirmation.

Servo display

The optical display of the current servo position can be seen by push-

ing the VIEW key () of the right four-way keys from the base display

so as from almost every other menu positions.
The current setting of each servo is displayed precisely between

-150% and +150% of the normal path taking into account the control

and servo settings, dual rate/expo functions, the interaction between

the linear and curve mixes, etc.
0% equals the middle position of the servo.
You can therefore check your settings without having to turn on the

receiver.

Attention

You have however to carefully test all the program steps on the

model before first use to make sure there are no errors!

For normal fixed wing models, the display follows the assignment

below:

–100%

+100%

STICK CALIBRATION

ONTRAST

ANGUAGE

OICE

DEUTSC

ENGLIS

TICK CALI.



