Innovative Wireless Technologies Inc FAP4213210 ユーザーズマニュアル
Revised: 9/25/2018
6650-16-0013, Rev. D
Page 8 of 15
4.2
COMPONENTS NECESSARY FOR INSTALLATION
The IMN installation uses the following components and accessories (refer to Section 6.0 for basic
installation instructions):
Mounting Hardware:
The IMN is supplied with mounting brackets at the four corners. A 0.3” diameter hole in the mounting
bracket allows appropriate screws, hooks, etc. to be used for mounting.
Antenna (900 MHz):
The specific 900 MHz antenna connected to the IMN RF port depends on the location of the IMN. For
below ground, use Yagi directional antenna assembly (IWT p/n: FAA9100-017) or Dipole omni-
directional antenna assembly (IWT p/n: FAA9100-027).
RF Power Splitters, Couplers, Attenuators:
The use of 2-way, 3-way, or 4-way power splitters and other RF accessories depends on the specific IMN
system installation configuration.
installation instructions):
Mounting Hardware:
The IMN is supplied with mounting brackets at the four corners. A 0.3” diameter hole in the mounting
bracket allows appropriate screws, hooks, etc. to be used for mounting.
Antenna (900 MHz):
The specific 900 MHz antenna connected to the IMN RF port depends on the location of the IMN. For
below ground, use Yagi directional antenna assembly (IWT p/n: FAA9100-017) or Dipole omni-
directional antenna assembly (IWT p/n: FAA9100-027).
RF Power Splitters, Couplers, Attenuators:
The use of 2-way, 3-way, or 4-way power splitters and other RF accessories depends on the specific IMN
system installation configuration.
ANTENNA 1
LED 2
POWER
LED 1
NETWORK
CABLE 1
POWER
POWER
MOUNTING
BRACKET
(4 X)
BRACKET
(4 X)
VENT
SWITCH
POWER
POWER
FIGURE 1: IMN CONNECTIONS