Omnidirectional Control Technology Inc. 0B390C02 ユーザーズマニュアル

- 28 - 

Set up the HyperTerminal with USB to serial port 

Follow the steps below to configure your HyperTerminal with USB to serial COM 

port setting: 

 

1.  Make sure that HyperTerminal is installed in your system. If not, please click 

Start, Settings, Control Panel, double click Add/Remove Programs, choose 

Windows Setup page, Communications, click Details button, enable 

HyperTerminal to install the program to your Windows system. 

 

2.  Please click on Start, Settings, Control Panel, double click System, and click on 

Device Manager. Check which COM port is located by USB to serial port.   

 

Figure 8 

 

3.  If you have setup HyperTerminal before, please run Start, Programs, 

Accessories, Communications, HyperTerminal, HyperTrm.exe. Click File, 

Properties. The Properties dialog page will appear on your screen. If it is your 

first time to setup HyperTerminal, you will see this page during the setup 

procedure.