Precor PRCR0111 ユーザーズマニュアル
20
Assembling the Atlas Treadmill
Completing Assembly
After the upright supports, the console, and the handrail
extensions are in place, replace the hood on the treadmill
base and finish securing the fasteners.
extensions are in place, replace the hood on the treadmill
base and finish securing the fasteners.
CAUTION: Be aware of the handrail extensions when you are
working around the front of the unit. It is easy to bump your
head or sustain other injuries if you ignore the location of the
handrail extensions.
working around the front of the unit. It is easy to bump your
head or sustain other injuries if you ignore the location of the
handrail extensions.
To complete assembly of the treadmill base:
1. Replace the hood.
Important: Use your fingers to align and thread the four
hood fasteners properly. Then use a wrench to tighten
the hood fasteners completely as described in the
following step.
hood fasteners properly. Then use a wrench to tighten
the hood fasteners completely as described in the
following step.
2. Secure the hood using four black buttonhead screws
and four black washers. Tighten the side fasteners
first, and then tighten the front fasteners.
first, and then tighten the front fasteners.
Figure 7: Hood and fastener placement
To secure the fasteners:
1. Using an alternating order, tighten the eight fasteners
that secure the upright supports to the treadmill base.
2. Fully tighten the six screws that secure the display
console to the upright supports.