Precor PRCR0111 ユーザーズマニュアル
Assembling the Treadmill
23
Checking Treadmill Alignment and Adjusting
the Running Belt
the Running Belt
Before you allow anyone to use the treadmill, you must
check the alignment of the running belt and adjust it as
needed. For more information, refer to
check the alignment of the running belt and adjust it as
needed. For more information, refer to
and
in the
Maintenance
chapter.
Leveling the Unit
The treadmill deck must be absolutely level from side to
side to keep the belt in alignment and ensure proper
operation. If the load is not equally distributed across the
treadmill deck, users may feel excessive vibration or
observe it at the display. You must make sure the deck is
level before allowing anyone to use the treadmill.
side to keep the belt in alignment and ensure proper
operation. If the load is not equally distributed across the
treadmill deck, users may feel excessive vibration or
observe it at the display. You must make sure the deck is
level before allowing anyone to use the treadmill.
Important: Observe the following precautions throughout
this procedure:
this procedure:
y
Adjust only one rear foot at a time.
y
Do not raise the unit beyond
³⁄₄
inch (2 cm).
y
Install the unit only on an absolutely even surface.
Adjusting the rear feet cannot compensate for
variations in the surface under the unit.
Adjusting the rear feet cannot compensate for
variations in the surface under the unit.
To level the treadmill:
1. Place a bubble level across the running belt to see
whether the treadmill is level.
Figure 11: Bubble level placement on running belt
If the treadmill … Then …
Is level
Skip to the next procedure.
Is not level
Continue with step 2.