L-3 Communications Aydin Corporation 6000-8501900 ユーザーズマニュアル

• P

AGE

modem (To configure the Terminal as a modem you

should use standard Windows modem configuration

procedure).

There are two data connection methods available:

GPRS DATA - With GPRS you are not charged

for the connection time but for your bandwidth

usage (amount of data tranferred). GPRS allows

you to make only outgoing calls, such as an internet

connection. See Appendices A & B for instructions

on how so set up a GPRS connection on your PC.

GPRS services must be registered with your

network operator in order to function.

GSM DATA - With GSM Data you are charged for

your time online. GSM allows both incoming and

outgoing calls. GSM Data connections are made the

same way as with a standard modem with your PC

configured for a fixed-line connection.

Since the GSM Terminal supports auto-bauding up

to 57,600 bps, make sure that maximum speed of

the PC modem is set to 57,600.

Also, you may need to use the following

initialization string, “AT+CSNS=4”, to accept calls

coming from outside of GSM network using single

numbering scheme.

Your SIM card must support GSM Data in

order to use this method.

Data Bearer Type Selection

The data bearer type selection dialing sequence

selects the bearer service with a data rate and a

service type to be used when making outgoing data

calls. Service type selection also applies to mobile

terminated (incoming) calls if the Single Numbering

Scheme is used. For incoming calls, bearer type

selection should match the network proposed service

type. If the unit is set to Transparent only and

the network proposes Non-Transparent only or vice

versa, then the call is released.

The default setting is Data Circuit Asynchronous

with Autobauding and Non-transparent only. This

dialing sequence updates the default bearer type

values stored in the GSM Terminal and the selected

OICE

ODEM

ODE