Novariant Inc. WMIA-166AGI ユーザーズマニュアル
Get the item 7 p/n 500-0313-01 Mini PCI Module. Connect the cable connector from step
4.2.5 as show in below. Tilt the PCI in a 45 degree angle and inset it to the J11 connector on
the TuRF board. Take the bracket p/n 202-0246-01 and slide in the top edge. Clear all cable,
tilt and lower the card into the Tilt the PCI module down toward the latch and lock into the
latch.
4.2.5 as show in below. Tilt the PCI in a 45 degree angle and inset it to the J11 connector on
the TuRF board. Take the bracket p/n 202-0246-01 and slide in the top edge. Clear all cable,
tilt and lower the card into the Tilt the PCI module down toward the latch and lock into the
latch.
Regulatory Information
The MiniPCI module is required to be professionally installed by a properly trained technician.
Improper installation or modifications not authorized by Novariant could void the user’s authority to operate the
equipment.
The device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. The device may not cause harmful interference.
2. The device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
RF Exposure Information
The Novariant module will be installed in close proximity to other radio modules. In order to maintain compliance with
FCC RF exposure requirements, this device must be installed in such a manner as to maintain separation distances shown
below between the antenna and all persons:
Insert connector
Slide in Bracket
Tilt down to the
latch align
bracket to
screw hole