Radiolink Electronic Limited RL037T001A ユーザーズマニュアル
12
To select model type:
1.Access the Model Select function in the programming mode (by pressing the
MODE“▲”and“▼” keys simultaneously and holding them down for one second). To select
the model memory, select model type, press the DATA “+” or “-” key until the desired model
number appears.
2.Press SELECT key after seeing on the screen the model memory where you want to
select model type. Then you will see “ACRO” and “HL” or “HELI” and “AC” on the screen.
3.To change model type, press the DATA “+” or “-” key and hold it down for about two
seconds. “HL” and “AC” blinks first, and then it stops blinking with a sound. The current
model type “ACRO” or “HELI” is displayed.
ACRO/HELI Model type select function
The Model type select function is used to select the ACRO or HELI mode of model type.
ACRO
: Powered aircraft memory type (with multiple wing and tail configurations. See Wing mixing type selection for further
information,p16)
HELI
: Helicopter memory type (with two helicopter swashplate type. See Swashplate types selection for further
information,p23)
CAUTION
: Before doing anything else to set up your aircraft, first you must decide Model type (include wing mixing type or
swashplate type) best fits this particular aircraft.
To assign a name
1.Access the Model Select function in the programming mode (by pressing the
MODE“▲”and“▼” keys simultaneously and holding them down for one second). To select
the model number you wish to change, press the DATA “+” or “-” key until the desired model
number appears..
2.Press SELECT key three times after seeing on the screen the model memory where you
want to set the model name. Then you will see the model name on the screen.
3.Choose a character for the first digit by using DATA “+” or “-” key. Then move to the next
digit by pressing the SELECT key and choose a character in the same way. Continue
choosing characters for the third and fourth digits. You can use up to four characters for the
name.
Model name function
Assign a name to the model memory. By giving each model a name that is immediately recognizable, you can quickly
select the correct model, and minimize the chance of flying wrong model memory that could lead to a crash.
REVR Servo Reversing
The servo reversing function is used to change the direction that a servo responds to a control input from the transmitter
(stick or switch). After using the reversing function, check all the controls on the model to be certain they are operating in
the correct direction and that you did not inadvertently reverse a servo other than the one intended. Reversing the wrong
servo (and not checking the response of the controls before each flight) may be the most common cause of a crash!
To reverse a servo:
1.Enter the programming mode and use the MODE“▲”or“▼” key to access the
REVR
function.
2.Use the SELECT key to select the channel you wish to reverse.
3.Press the DATA “-” key to reverse the servo (REV), or press the DATA “+” key to make
the servo operate normally (NOR). The arrow will indicate the condition of the servo
(normal or reversed).
4.Use the SELECT key to display other channels to be reversed