Triotronik S/FTP CAT6 70m PKW-PIMF-KAT6 70.0 BR ユーザーズマニュアル
製品コード
PKW-PIMF-KAT6 70.0 BR
7
www.triotronik.com • A-8160 Weiz • Florianigasse 5 • t +43 3172 42299-0 • f +43 3172 42299-11 • office@triotronik.com
Wirewin
®
Gesamtschirm verdrillen oder
einfach über den Kabelmantel
nach hinten ziehen. Kabelpärchen
durch die Adernaufnahme führen.
Adern so nah wie möglich an der
Adernaufnahme mit einem
Seitenschneider abschneiden.
Einzelne Adern entsprechend dem
aufgedruckten Farbcode einlegen.
Es bleibt die Verdrillung so weit
wie möglich erhalten.
Kamm in den Keystone Jack
einführen.
Markierung und Verriegelung
schützen vor falschem Aufsetzen
im Jack
Danach die beiden Flügel zusam-
mendrücken
Der Jack rastet durch den
Druck ein und drückt die Adern
automatisch in die vorgesehenen
Schneidklemmen im Jack
Somit ist kein Aufschaltwerkzeug
mehr notwendig
Zum Schluss wird noch die Schir-
mung mit einem mitgeliefertem
Kabelbinder befestigt - FERTIG
Unterschied
KAT6 zu KAT6A Jack
Unser
KAT6
A
Jack hat eine 360°
Schirmung - der KAT6 Jack
nicht. Dieser hat nur eine 180°
Schirmung. Natürlich sind die
elektrischen Werte beider Jacks
auch unterschiedlich.
Mit diesem Merkmalen kann man
die Jacks sehr rasch unterschei-
den!
Die „Überlänge“ der Adern an der
Adernaufnahme darf max. 0,5mm
betragen, ansonsten kann es zu
einem Kurzschluss am Gehäuse
kommen.
Strip a minimum of 25mm of
jacket from the end of cable and
pull the shield back. Adjust the
pairs according to the colour code
and insert the wires into the cap.
Cut the excess wire off, as close
to the edge of the cap as possible.
Insert the wires into their correct
position based upon the colour
code.
Make sure that the arrows on the
jack and the cap face in
the same direction.
Align the cap with the IDC
towers and press it into
position.
Redate the wings toward each
other until they snap closed.
Ensure that the drain wire is
wrapped aroand the cable
and shield.
Tie-wrap the drain wire to the
shield. Do not over tighten the tie
wrap. If necessary cut the excess
shield without damage the cable
jacket.
Difference between
CAT6 to CAT6A Jack
Our
CAT6
A
Jack have 360° shield
contact the CAT6 Jack have only
180°. Of course the electrical
character is much better for the
CAT6
A
. You can see the difference
therefore very easy!
180° Contact (KAT6)
360° Contact (KAT6A)
ATTENTION: The tips of wires
have
to predude no more than 0,5mm.