4RF Limited SRN0400025A ユーザーズマニュアル
Maintenance | 211
Aprisa SR User Manual
Single Radio Software Upgrade
The software upgrade procedure is different for an Aprisa SR Protected Station (see ‘Protected Station
Software Upgrade’ on page 32).
Software Upgrade’ on page 32).
Note: If a radio has been configured for a Protection Type of ‘Redundant’ (see ‘Protected Station:
Terminal > Operating Mode’ on page 169), and that radio is no longer part of a Protected Station, the
Protection Type must be changed to ‘None’ before the radio software upgrade can be achieved.
Terminal > Operating Mode’ on page 169), and that radio is no longer part of a Protected Station, the
Protection Type must be changed to ‘None’ before the radio software upgrade can be achieved.
File Transfer Method
This process allows customers to upgrade a single Aprisa SR radio.
The Software Pack is loaded into the radio with the file transfer process (see ‘Software > File Transfer’ on
page 146) and activated (see ‘Software > Manager’ on page 149).
page 146) and activated (see ‘Software > Manager’ on page 149).
Upgrade Process
The Aprisa SR upgrade operation is indicated by a flashing orange AUX LED.
To upgrade the Aprisa SR radio software:
1. Unzip the software release files in to the root directory of a USB flash drive.
2. Check that the SuperVisor USB Boot Upgrade setting is set to ‘Disabled’ (see ‘Software > Setup’ on
page 145).
3. Insert the USB flash drive into the Host Port
.
4. Using File Transfer, load the software pack into the radio (see ‘Software > File Transfer’ on page 146).
5. Activate the software on the radio (see ‘Software > Manager’ on page 149).