RLW Inc. RLW88844422 ユーザーズマニュアル
wSIM™ FAE WiTry Kit Operation Quick Start Guide
6
NOTE
The switch should remain in the OFF
position for now.
1.1.2 wSIM™ Mesh Network Gateway
Remove the Mesh Network Gateway and Power Adapter. Place the gateway on a
flat surface near your computer and approximately in the center of the wSIM
Processing/Communication Modules. Attach the power adapter to the gateway
flat surface near your computer and approximately in the center of the wSIM
Processing/Communication Modules. Attach the power adapter to the gateway
only.
NOTE
The power adapter should remain
UNPLUGGED for now.
Remove the Ethernet Crossover Cable from the case. Plug one end into the
gateway Ethernet port and the other into an Ethernet port on your computer.
gateway Ethernet port and the other into an Ethernet port on your computer.
1.1.3 Accelerometers and Thermocouples
Remove the three accelerometers and thermocouples and their associated
cables from the case. Connect one accelerometer and one thermocouple to the
appropriate connector on each wSIM Processing/Communication Module. The
cables from the case. Connect one accelerometer and one thermocouple to the
appropriate connector on each wSIM Processing/Communication Module. The
connectors are different and will allow only the accelerometer to connect to the
accelerometer connector and the thermocouple to the thermocouple connector.
If you have access to a vibrating source (shaker table, air vent, motor, etc.)
attaching the accelerometer(s) to it will provide some excitation to the channel.
accelerometer connector and the thermocouple to the thermocouple connector.
If you have access to a vibrating source (shaker table, air vent, motor, etc.)
attaching the accelerometer(s) to it will provide some excitation to the channel.