Guangzhou Chiyuan Electronic Co. Ltd. N-6 ユーザーズマニュアル
N-6
INSTRUCTION MANUAL
CAUTION
2.4G Binding
! To work your R/C with your models correctly and safely, read this
manual carefully and keep it in a safe way as a reference introduction in the
manual carefully and keep it in a safe way as a reference introduction in the
future.
Warning:
1. This product is only equipped for radio controlled models;
2. The usage of this product should be approved by local relevant law or
1. This product is only equipped for radio controlled models;
2. The usage of this product should be approved by local relevant law or
regulations;
3. We will not be responsible for the damages caused by unauthorized
modification, adjustment or replacement of parts of this product;
4. The manual may be altered without prior notice. Please contact us if
you have any corrections or clarifications that should be made in the manual..
! Before starting the transmitter, make sure the transmitter batteries are
well loaded .The voltage of transmitter batteries is never lower than 8.6V. And
! Before starting the transmitter, make sure the transmitter batteries are
well loaded .The voltage of transmitter batteries is never lower than 8.6V. And
please check and confirm that the servos are all well and properly connected.
! Keep the radio system away from moist, high temperature and strong
shake. Do not clean the product with solvent.
! The antenna does not touch anything else when power switch is turned
on. Do not leave this product and its accessories within the reach of small
! Keep the radio system away from moist, high temperature and strong
shake. Do not clean the product with solvent.
! The antenna does not touch anything else when power switch is turned
on. Do not leave this product and its accessories within the reach of small
children.
! Please use this product according to your local relevant law or
regulation, we are not responsible for any incidents or damages.
! Please use this product according to your local relevant law or
regulation, we are not responsible for any incidents or damages.
Connection Diagram(For FIXED-WING)
6-Channel 2.4G Radio Control System
Power Switch
Left Stick
2.4G DSSS Technology
Right Stick
Reverse SW
Thank you for purchasing our R/C system.
Before using, read this manual carefully.
Charging Jack
1. Press and hold the bind button on the back of the transmitter while
Turning on the power switch,until LED normally displays.
3. LED(Xy600) should be go solid,
i n d i c a t i n g t h e s y s t e m h a s
connected.
Now remove the bind plug and
d i s c o n n e c t t h e b a t t e r y .
LIGHT
Xy600
FLASH
Xy600
2. With the system hooked up as
shown, insert the bind plug in the
charge plug receptacle.Turn on the
power of the receiver (4.8~5.6v),
and now LED(xy600) should be
flashing indicating that the
receiver is ready to bind.
Receiver channel distribution:
Ch1:
Ch1:
Ch2:
Ch3:
Ch3:
Ch4:
Ch5: Flap
CH6: AUX
Ch5: Flap
CH6: AUX
Aileron
Elevator
Throttle
Rudder
Elevator
Throttle
Rudder
RIGHT STICK
LEFT STICK
Transmitter
(Mode 1)
THRO
Ch6
CH5
Ch4
CH3
CH2
CH1
CH5
Ch4
CH3
CH2
CH1
Xy600
Servo1
Motor
ESC
AILE
AILE(BIND)
Transmitter
Type: N-6
Channels: 6
Frequency: 2.4G
DC: 9.6V,≤250mA
Meas.: 210*190*85mm
Channels: 6
Frequency: 2.4G
DC: 9.6V,≤250mA
Meas.: 210*190*85mm
(Packing meas.）
Net weight: 390g
Net weight: 390g
Technology Data
Receiver
Type: XY600
Channels: 6
Frequency: 2.4G
DC: 4.8~5.6V,≤40mA
Net weight: 13.5g
Channels: 6
Frequency: 2.4G
DC: 4.8~5.6V,≤40mA
Net weight: 13.5g
ELEV
RUDD
Servo2
ELEV
Servo3
RUDD
!
Receiver channel distribution:
CH1: Aileron ; CH2: Elevator ; CH3: Throttle ; CH4: Rudder; Ch5: Flap ;
CH6: AUX
CH6: AUX
Stick
Aileron Stick
Transmitter
Ch1
Ch2
Receiver channel mixing
Elevator Sticker
+50%
+50%
+50%
+50%
-50%
-50%
Swi tch Swi tch1 Swi tch2 Swi tch3 Swi tch4 Swi tch5 Swi tch6
Reverse
Aileron
Reverse
Elevator
Reverse
Throttle
Reverse
Rudder
Reverse
Mode1
Mode2
Connection Diagram(For DELTA)
! Switch to “DELTA” position and enter DELTA mode, aileron and
elevator is mixed, as for triangle planes, tailless planes.
Antenna
Handle
LED
BIND(Press and hold )
Power sw(turn on )
1
2
Bind SW
Plane select SW
(Fixed-Wing & Delta)
Mode SW
CH5
Ch6
Ch6
Servo4
Channel 5
Servo5
Channel 6
Fixed-Wing
Delta
Swi tch Swi tch1 Swi tch2 Swi tch3 Swi tch4 Swi tch5 Swi tch6
Reverse
Aileron
Reverse
Elevator
Reverse
Throttle
Reverse
Rudder
Reverse
Mode1
Mode2
! Switch to “FIXED-WING” position and enter Fixed-Wing Plane mode,
aileron and elevator is mixed, as for triangle planes, tailless planes.
Fixed-Wing
Delta
Output Power: ≤20dBm
Modulation: DSSS
Frequency Range:
Number of channels:
Number of channels:
(Randomly selected)
Antenna Parameters: Gain(3dBi)/ VSWR(≤1.5)/ Impedance(50ohm)
Changes or modifications not expressly approved by the party responsible for compliance
could void the user authority to operate the equipment.
FCC ID:V6KN-6
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1)this device may not cause harmful interference, and(2)this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
2403MHz-2480MHz
78