Jetrich Electronic Co. Ltd JR-D008R ユーザーズマニュアル
USER MANUAL
Remote Dog Trainer
Controller:
2 training modes. Sound and vibration
Press the sound button. The sound will be activated
Press the vibration. The vibration will be activated.
When the sound or vibration be activated. If the button is L. it means is it will be
activated.
When the button is on Automatic modes
When you press the sound button or vibration button. it will be activated.
Receiver:
Turn the button to on position then the receiver working receiving mode.
Turn the button to off position then the power off.
2 training modes. Sound and vibration
Press the sound button. The sound will be activated
Press the vibration. The vibration will be activated.
When the sound or vibration be activated. If the button is L. it means is it will be
activated.
When the button is on Automatic modes
When you press the sound button or vibration button. it will be activated.
Receiver:
Turn the button to on position then the receiver working receiving mode.
Turn the button to off position then the power off.
Federal Communications Commission (FCC) Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the