Industrial Scientific Corporation RGX ユーザーズマニュアル

 

42 

 

 

 

When working inside the unit, avoid accessing the battery, other exposed 
components, and any item that is protected by the unit's interior plastic 
cover. Avoid dropping or spilling anything into the case.  
x  Using a torx screwdriver with a T25 bit, unscrew and remove the four 

screws that secure the case lid to the case base. Set aside the 

screws for later reinstallation. 

x  The unit is hinged on the left; open the case lid from right to left.  
x  Bring in the customer-supplied Ethernet cable, power lines, or both 

through the customer-installed conduit-hub. If both an Ethernet cable 
and fixed DC power are to be used, it is recommended that the cable 
occupy one conduit and the power lines occupy the other, following 

AHJ requirements.   

x  Use the diagram below to locate the optional connection ports to be 

used: the terminal block, Ethernet cable port, and guides.  

 

 

Protective cover

 

 

RJ45 port 

 

Guides (4x) 

 

 Terminal 

block

 

 

7 

Connect power  

 

 Next, 

choose 

only one instruction set below─a or b, but not both─to 

connect only one external power source to the RGX.  
WARNING: Only one of the following power input ports is permitted to be 
connected at a given time: 12V Charger Port, IS Power Port, or 9–30 
VDC Terminal Block.  

 

WARNING: Only one of the following power input ports is permitted to be 
connected at a given time: 12V Charger Port, IS Power Port, or 9–30 
VDC Terminal Block. 
If the RGX will draw operational power from a compatible power supply 

accessory (ISERTPS or ERTPS), connect the power supply's IS cable to 
the RGX IS Cable Adapter. 
Ensure the ISERTPS or ERTPS is installed, connected, and used in 

accordance with the instruction provided in its product manual. 

Skip to step 8

. 

 

 
 
 
 
 

GND 

Modified: 2018-05-25 13:18:14 EDT

Drawn By: Gaygan, Nancy

Created: 2018-05-16 10:24:51 EDT

Rev: 1

Printed By: Kuzmich, Bob

Int: 1.5

Date:May 29, 2018