Mandolyn Electronic Technology Inc. TR430 ユーザーズマニュアル

ON/OFF

LEARN

REMOTE CONTROL RECEIVER

TR430 remote control transmitter

   Congratulations on your 
purchase of a UPM slim 
remote control transmitter.  
This unit is specifically 
designed to work with 
UPM brand receivers.  
Please take the time to 
read and understand this 
manual so you can begin 
to enjoy the convenience 
this product can offer.

!

433 MHz RF technology

!

Intelligent code learning

!

Control up to 4 remote 
receivers

!

Ultra-slim design with 
flush wall-mount 
bracket

!

Master On/Off

!

Transmission range of 
up to 40 meters in open 
area

battery installation

1

2

1

2

remove the battery cover from 
the back of the transmitter

place two button cell batteries 
between terminals observing 
proper polarity then replace 
cover

Transmitter stops turning 
receiver on and off.
   

Use the LEARN function to 
reprogram the receiver
or
Check the battery

problem

solution

Battery Type:

2 x 1.5V button cell

System Source:

4,096 code combinations

Transmission Frequency:  433 MHz
Transmission Range:  up to 40 meters in open area

2

3

Repeat       and       for any additional 
receivers (available at your local 
retailer) using available channels

Press LEARN on receiver while 
simultaneously pressing the desired 
channel button on the transmitter

TR430 Transmitter

3

the green LED will light up 
with any key press once the 
battery is installed correctly

1

3

1

Plug receiver into wall socket

4

If LEARN completed successfully, 
the LED on the receiver should 
light up when ON is pressed

button descriptions

1

Turn each receiver On/Off 
individually by using the channel 
On/Off keys on the transmitter

3

4

1

2

2

1

Turn all receivers On or Off at 
the same time by using the 
ALL ON / ALL OFF button

If you have more than one receiver set up, you can use the Master On/Off 
function to simultaneously turn ALL the receivers (of the same house code) On 
and Off at the same time.

Channel 1 ON

ALL ON

Channel 4 ON

Channel 3 ON

Channel 2 ON

Channel 1 OFF

ALL OFF

Channel 4 OFF

Channel 3 OFF

Channel 2 OFF

LED Indicator

The learn function must be performed to allow the receivers in your system to 
recognize the transmitter.  More than 4,000 code combinations eliminate the 
possibility of interference by other transmitters.

Note that a generic model of receiver is used for illustration here.  Please 
refer to the accompanying owners manual for the operations of your 
specific receiver.

*

1

This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in 
a residential installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Warning:
Changes or modifications made to this equipment not expressly approved by 
the manufacturer may void the FCC authorization to operate this equipment.