Meisida Electronic Toys Co. Ltd MSD03431989 ユーザーズマニュアル
7
8
Method of charging the battery
1. The battery should be installed correctly on the charger
(see the illustration).
2. Install the 6.0V battery pack in the direction of arrow into
the charger. Then plug into household socket
appropriately.
3. Charge duration normally is 4~6 hours. No charge is
allowed after this.(About 8 hours required for the first
time of charging).
4. Pull the charger off the socket after finish charging , press
the lock button in the charger and take out the battery pack.
(see the illustration).
2. Install the 6.0V battery pack in the direction of arrow into
the charger. Then plug into household socket
appropriately.
3. Charge duration normally is 4~6 hours. No charge is
allowed after this.(About 8 hours required for the first
time of charging).
4. Pull the charger off the socket after finish charging , press
the lock button in the charger and take out the battery pack.
Notes:
1. The attached battery is not charged yet. Make sure to
charge it prior to use.
In the course of charging it is normal that temperature of
the charger and battery will be on the rise.
2. Termly check if the plug, crust and other parts are in good
condition. If breakage found they should be stopped using
charge it prior to use.
In the course of charging it is normal that temperature of
the charger and battery will be on the rise.
2. Termly check if the plug, crust and other parts are in good
condition. If breakage found they should be stopped using
until e repaired into good condition.
3. The charger and battery are not toys. They should be
charged and used under adult supervision.
charged and used under adult supervision.
1. Put the switch in the “OFF” position.
2. As per the illustration ,put the fully charged 6.0V
battery pack into the battery case after checking the
positive and negative poles (The red band installed into
battery case with the battery), then close the battery
cover and fasten the lock to fix the battery.
3. If re-charge for the battery required, put the switch
in “OFF” position. Unlock the battery cover and take out
the battery for recharging through lifting the red band.
4. Deceleration of the car may be caused low power off battery.
2. As per the illustration ,put the fully charged 6.0V
battery pack into the battery case after checking the
positive and negative poles (The red band installed into
battery case with the battery), then close the battery
cover and fasten the lock to fix the battery.
3. If re-charge for the battery required, put the switch
in “OFF” position. Unlock the battery cover and take out
the battery for recharging through lifting the red band.
4. Deceleration of the car may be caused low power off battery.
1. Don't connect the toy to the voltage which is higher
than recommended.
2. Make sure the loading & unloading of the battery of
the toy car is under adult supervision.
Remarks:
ON
FF
O
M
n pow w c
ai
er s it h
Red Band
6.0v Charger
Lock for
battery
battery
6.0v Chargeable battery
INPUT: AC-Household
Voltage 50/60HZ
OUTPUT: DC 6.75V 200mA
Voltage 50/60HZ
OUTPUT: DC 6.75V 200mA
Loading & Unloading of the Battery of the Toy Car
Loading & Unloading of the Battery of the Toy Car
0
6 .
V
0
6 .
V
Methods of Charging the Battery & Cautions
Methods of Charging the Battery & Cautions