IKUSI ELECTRONICA S.L. RAD-RF ユーザーズマニュアル

 

 

 
 
Proceed with caution; Incorrect connections may lead to unforeseeable movements 
on starting-up. 
 
 
Remember that the receiver has several voltage-powered circuits. Even when the 
receiver’s power supply has been cut off, there is still a risk of electrical shocks. 
 
 
 
Once the receiver has been connected, disconnect the power supply to the motors

 

(if 

possible), for example, by removing the fuses and power on the receiver. The receiver 
will enter into the SCANNING mode while the transmitter is off. The following receiver 
LEDs should now light up: 
 
 

POWER: 

ON, indicating that the power supply is correct. 

HARDOK:  ON, indicating the absence of defects on the board. 

SIGNAL: 

OFF if all radio channels in the band are free. 
Flashing ON if the receiver is finding channels with RF signals.  

DATA: 

OFF if none of the radio channels contains signals belonging to a 
RADF13 or RADS11 radio remote control system in the area. 
Flashing ON if some do. 

ID: OFF. 

 

To enter into Normal Working mode follow the sequence: 
 

1.  Put a charged battery in the transmitter. 
2.  Turn on the key-switch  
3.  Push down STOP pushbutton (if the button was in up position) 
4.  Pull up STOP pushbutton. The transmitter LED should flash yellow-green for a 

second. 

5. Press START

 The transmitter LED should light up green indicating that 

the transmitter is transmitting. 

RADS11 and RADF13 Users Manual ver1.2.doc 
KCI Hoists Corp.  reserves the right to modify this information without prior notification. 

Page 11 of 20