IKUSI ELECTRONICA S.L. RAD-RF ユーザーズマニュアル

 

 

 
For RADF13 systems, there is a special “Service Mode” of operation for maintenance 
and set up of the Hoist Condition Monitoring Unit via radio. 
 
This unit is connected to the receiver RAD-RF by a serial data communication 
CL20mA. 
 
When in Service mode, the transmitter RAD-TF is able to act as a data console for the 
Hoist Condition Monitoring Unit, sending commands and receiving information, using 
the radio link and the appropriate software in the transmitter RAD-TF and in the receiver 
RAD-RF. 
 
During the Service Mode of operation, due to the amount of data being sent in the 
reverse link, the amount of frames per second in reverse mode is increased such that the 
feedback in the display is fast enough. The movements of the crane in this mode of 
operation are inhibited, this is, there are no movement orders being sent by the 
transmitter or acknowledged by the receiver. The Stop relays are activated. 
 
PLEASE NOTE: 
 It could be too slow to enter in service mode by the receiver if the transmitter and the 
receiver are in different channels. Whenever possible, avoid the scanning of radio 
channels. 
 
4.2 

 

To access the Hoist Condition Monitoring Unit mode follow 
the sequence: 
 

1.  Install a charged battery in the transmitter. 
2.  Move close to the receiver. 
3.  Turn on the key-switch. 
4. Push down STOP pushbutton (If it was in up 

position.  

5.  Pull up STOP pushbutton. 
6. Press Pushbutton UP in second step, and then, 

START 

. The system enters in Service 

Mode. See figure 7. 

 

RADS11 and RADF13 Users Manual ver1.2.doc 
KCI Hoists Corp.  reserves the right to modify this information without prior notification. 

Page 15 of 20