IKUSI ELECTRONICA S.L. RAD-TS ユーザーズマニュアル
6 HOW TO ACCESS TO THE CRANE CONDITION
MONITORING UNIT IN RADF13 SYSTEM. SERVICE
MODE.
6.1 General Description of Service Mode
MODE.
6.1 General Description of Service Mode
For RADF13 systems, there are a special “Service Mode” of operation for
maintenance and set up the Crane Monitoring Unit PREMIUM via radio.
maintenance and set up the Crane Monitoring Unit PREMIUM via radio.
This unit is connected to the receiver RAD-RF by a serial data communication
CL20mA.
CL20mA.
When in Service mode, the transmitter RAD-TF is able to acts as a data console
for the PREMIUM control unit, sending commands and receiving information,
using the radio link and the appropriate software in transmitter RAD-TF and in
receiver RAD-RF.
for the PREMIUM control unit, sending commands and receiving information,
using the radio link and the appropriate software in transmitter RAD-TF and in
receiver RAD-RF.
During the Service Mode of operation, due to the amount of data being sent in the
reverse link, the amount of frames per second in reverse mode is increased such
that the feedback in the display is fast enough. The movements of the crane in this
mode of operation are forbidden, this is, there are no movement orders being sent
by the transmitter or acknowledged by the receiver. The Stop relays are activated
however.
reverse link, the amount of frames per second in reverse mode is increased such
that the feedback in the display is fast enough. The movements of the crane in this
mode of operation are forbidden, this is, there are no movement orders being sent
by the transmitter or acknowledged by the receiver. The Stop relays are activated
however.
PLEASE NOTE: It could be too slow to enter in service mode by the receiver if
the transmitter and the receiver are in different channels. Whenever possible,
avoid the scanning of radio channels.
the transmitter and the receiver are in different channels. Whenever possible,
avoid the scanning of radio channels.
6.2
Entering the Service mode.
To access the Crane Condition Monitoring Unit mode
follow the sequence:
follow the sequence:
1. Put a charged battery in the transmitter.
2. Move close to the receiver.
3. Turn on the key-switch.
4. Push down STOP pushbutton.
5. Pull up STOP pushbutton.
6. Press Pushbutton UP in second speed, and then,
2. Move close to the receiver.
3. Turn on the key-switch.
4. Push down STOP pushbutton.
5. Pull up STOP pushbutton.
6. Press Pushbutton UP in second speed, and then,
START
. The system enters in Service
Mode. See figure 7.
Figure 7
Entering the Service mode.
RADS11 and RADF13 Users Manual ver0.4a.doc
KCI Hoists Corp. reserves the right to modify this information without prior notification.
KCI Hoists Corp. reserves the right to modify this information without prior notification.
Page 15 of 23