Wilson Electronics LLC 271265 ユーザーズマニュアル

Typical Installation

Power 

Supply

Signal 

Booster

Inside Antenna

Outside Antenna

1

3

2

1  Select a location to install the signal booster that is away from excessive heat, 

direct sunlight and moisture. 

2  Select a location on the roof of the building to install the outside antenna. Use a 

cell phone in test mode to find the strongest signal from the cell tower (see pg. 5). 

Visit wilsonelectronics.com to find the test mode function for your particular cell 

phone.

3  Select a location for the inside antenna, preferably in the center of where the signal 

needs to be amplified. Separation between the  booster and the inside antenna 

must be a minimum of 10 feet, to prevent oscillation.

4  Verify that both the outside antenna and the inside antenna are connected before 

powering up the signal booster.

  Lightning protection is recommended for all in-building installations.
5  Separation distance between the inside and outside antennas must be a minimum 

of 50 feet, 75 feet is even better.

EASY TO INSTALL
The following steps provide a summary of the signal booster/antenna installation 

process.  However, they are 

not a substitute for the complete installation 

instructions on the following pages, which you should read thoroughly.  Contact 

Wilson’s Technical Support Department with any questions at 866-294-1660.

Warning: See RF safety 

warning on page 5.