Wilson Electronics LLC 271865 ユーザーズマニュアル

Cell Tower

(sold separately)

The Outside Antenna should be mounted as shown in the 

illustration above . The mounting bracket, included with Outside 

Antenna, is adjustable and will accommodate pipe diameters 

from 1 .25” to 2” (pipe sold separately Part# 901117) . Mount the 

antenna so that there is at least 3 feet of clearance in all directions 

around it . Position the antenna so that it has an unobstructed line 

of sight to the cell tower’s strongest signal . Make sure the Outside 

Antenna is not pointing across your own roof or at the Inside 

Antenna as this will cause the oscillation protection circuitry to 

shut down the Signal Booster .

 Lightning protection is recommended for all installations (sold  

                              separately) (Part #859902) . Take extreme care to ensure  that neither  

 

              you nor the antenna comes near any electric power lines .

Install the Lightning Surge 

Protector (LSP) close to 

the Signal Booster .  Attach 

the cable from the Outside 

Antenna to the surge 

protector, using a short 

length of low loss cable; 

attach one end to the LSP 

and the other to the Outside 

Antenna connector on the 

Signal Booster .  Attach a 

ground wire (not included) 

to the LSP .  LSP may be 

purchased at www.WilsonElectronics.com or 800-204-4104 .