Wilson Electronics LLC 272365 ユーザーズマニュアル

Select a location to install the Signal Booster that is away 

1 . 

from excessive heat, direct sunlight, moisture and has proper 

ventilation .  Do not place the Signal Booster in an air-tight 

enclosure . 
Select a location on the roof of the building to install the Outside 

2 . 

Antenna . Use a cell phone in test mode to find the strongest 

signal from the cell tower . Visit www.WilsonElectronics.com  

to find test mode function for your particular cell phone (see 

page 11) .
Run the Outside Antenna cable to the Signal Booster and 

3 . 

attach it to the connector labeled “Outside Antenna” on the 

Signal Booster . Run the Inside Antenna cable to the Signal 

Booster and attach it to the connector labeled “Inside Antenna” 

on the Signal Booster (see page 7 for more information on 

running cable) . Lightning Surge Protection is recommended for 

all in-building installations (see page 6) .
Select a location for the Inside Antenna, preferably in the 

4 . 

center of where the signal needs to be amplified . A minimum 

separation distance (combined vertical/horizontal) of 20 feet is 

necessary for operation (see page 8) . If the inside coverage is 

not sufficient you may need as much as 50 feet of separation . 

See installation diagram on pages 3 & 4 . 
Before powering up the Signal Booster, verify that both the 

5 . 

Outside Antenna and the Inside Antenna are connected and 

check that all connections are tight . 

on the connectors.
The Signal Booster has been packaged with the gain control 

6 . 

knobs adjusted to the highest gain position . If the light is not 

green, please refer to pages 13 & 14 .
Warning: 

Connecting the Signal Booster directly to a cell phone 

with use of an adapter may damage the cell phone and the 

Signal Booster .

See Installation Diagram on page 3 . Contact Wilson Electronics 

Technical Support Team with any questions at 866-294-1660 .