Wilson Electronics LLC 274080 ユーザーズマニュアル

Select a location to install the Signal Booster that is away from 

1 . 

excessive heat, direct sunlight, moisture and has proper ventilation .  

Do not place the Signal Booster in an air-tight enclosure . 
Select a location on the roof of the building to install the Outside 

2 . 

Antenna (see page 5) . Use a cell phone in test mode to find the 

strongest signal from the cell tower . (see page 6) . Visit  

www.WilsonElectronics.com to find the test mode function for your 

particular cell phone . 
Run the Outside Antenna cable to the Signal Booster and attach it to 

3 . 

the connector labeled “Outside Antenna” on the Signal Booster . Run 

the Inside Antenna cable to the Signal Booster and attach it to the 

connector labeled “Inside Antenna” on the Signal Booster . See page 

7 for more information on running cable . Lightning Surge Protection 

is recommended for all in-building installations (see page 6) .
Select a location for the Inside Antenna, preferably in the center of 

4 . 

where the signal needs to be amplified (see page 8) . A minimum 

separation distance of 20 

vertical feet is necessary for operation . If 

the inside coverage is not sufficient you may need as much as 75 feet 

of 

horizontal separation . See installation diagram on pages 3 & 4 . 

Before powering up the Signal Booster, verify that both the Outside 

5 . 

Antenna and the Inside Antenna are connected and check that 

all connections are tight (see page 9) . 

connectors. 
The Signal Booster has been packaged with the gain control knobs 

6 . 

adjusted to the highest gain position . If the light is not green, please 

refer to pages 10-11 .

See Installation Diagram on page 3 . Contact Wilson Electronics Technical 

Support Team with any questions at 866-294-1660 .

Connecting the Signal Booster directly to a cell phone with  

 

use of an adapter will damage the cell phone and/or the  

 

Signal Booster .

It is very important to power your Signal Booster using a 

•

surge protected AC Power Strip with at least a 

Failure to do this will void your warranty in the 

•

event of a 

power surge or lightning strike .