Wilson Electronics LLC 2B1216 ユーザーズマニュアル

Select a location to install the Signal Booster that is away from excessive heat, direct 

1 . 

sunlight, moisture and that has proper ventilation .  Do not place the Signal Booster in 

an air-tight enclosure . 
Select a location on the top of the structure to install the Outside Antenna . Use a cell 

2 . 

phone in test mode to find the strongest signal from the cell tower . Visit  

www.WilsonElectronics.com to find test mode function for your particular cell phone .
Run the Outside Antenna cable to the Signal Booster and attach it to the connector 

3 . 

labeled “Outside Antenna .” 
An external adapter is required to connect the cell phone or cellular data card to the 

4 . 

Signal Booster . The external adapter plugs into the included antenna extension cable 

and directly into a socket on the cellular device . Run the extension cable from the 

external adapter and attach it to the connector labeled “Inside Antenna” on the Signal 

Booster .  

 

Before powering up the Signal Booster verify that both the Outside Antenna and the 

5 . 

Inside Antenna are connected and check that all connections are tight . An AC surge 

protector is recommended for all installations (not included) .

The following steps provide a summary of the Signal Booster/antenna installation process .  

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 .

Powerstrip Surge Protector

Power Supply

GSM Hi-Power

Signal Booster

Cellular Modem

Mini-Magnet

Antenna

(Figure 1)

 It is very important to power your Signal Booster using a surge protected AC Power Strip with at least a 1000 Joule rating.