Wilson Electronics LLC 2B1225 ユーザーズマニュアル

Select a location to install the signal booster that is away from excessive heat, direct 

1 . 

sunlight, moisture and that has proper ventilation .  Do not place the signal booster in 

an air-tight enclosure . 
Select a location on the top of the structure to install the outside antenna . Use a cell phone 

2 . 

in test mode to find the strongest signal from the cell tower . Visit  

www.WilsonElectronics.com to find test mode function for your particular cell phone .
Run the outside antenna cable to the signal booster and attach it to the connector 

3 . 

labeled “outside antenna .” 
An external adapter is required to connect the cell phone or cellular data card to the 

4 . 

signal booster . The external adapter plugs into the included antenna extension cable 

and directly into a socket on the cell phone or cellular data card . Run the extension 

cable from the external adapter and attach it to the connector labeled “cellular phone 

or data card” on the signal booster .  

 

the connectors. Ensure all cables have a tight connection.
Before powering up the signal booster verify that both the outside antenna and the 

5 . 

inside antenna are connected and check that all connections are tight . An AC surge 

protector is recommended for all installations .

The following steps provide a summary of the signal booster/antenna installation process .  

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 .

(Figure 1)

AC Surge 

Protector