Wilson Electronics LLC 2B5325 ユーザーズマニュアル

In-Building Installation
Installing a Wilson electronics Outside Antenna in a Building
Follow the specific antenna instructions included with the Outside Antenna (sold separately except for 

certain kits) . These instructions assume that you are using a Wilson Electronics Mini-Magnet Mount 

Antenna and the optional suction cup window bracket .
To receive the best signal, select a window on the side of your building where your outside signal is the 

strongest . 

Attach the suction cup bracket to the inside of a window so that the cable will reach 

the location of the Sleek . Place the bracket as high on the window as possible for 

best performance .

Once the bracket is in place, attach the magnet base of the antenna to the flat 

surface of the bracket . 

The Wilson Electronics Sleek may be placed in any convenient indoor location, such as a desk or 

tabletop . The cell phone or data card must be in the cradle and a Bluetooth headset used for voice 

communications . 

Attaching the Antenna
Once you have selected the location for the Sleek, run the cable from the outside antenna and attach it 

to the SMA connector on the bottom of the Sleek . 
Note: The cell phone must be placed in the Sleek cradle to amplify properly.

 

Warning: The Sleek and the Outside Antenna must have a minimum separation of 3 feet to  

It is very important to power your Signal Booster using a 

• 

surge protected AC Power Strip with at least a 

Failure to do this will void your warranty in the 

• 

event of a 

power surge or lightning strike .